This project was I’m pretty good shape. So we just replace the seat foam, and recovered seats and carpet.

This boat seats 12

We went back with the same color scheme.

New carpet!

Call us today!

This customer saved money, by removing the parts and installing them himself.

We changed the color scheme and reattached the wood with screws an brads.

The captains chair needed a little more attention.

Give us a call!

This customer took the cushions out himself and saved some money on installation. We picked out a color scheme that was close to the original. We will post more pics of the upholstery installed when the customer gets them to us.

Give us a call we are offering off season discounts

 

 

Marine upholstery restoration; using PermaGaurd marine vinyl, 110-55 marine high density foam,marine bonded UV thread,stainless steal 3/8″ staples, Weldwood spray grade adhesive. The floor was sealed with marine polyurethane prior to carpet installation. Carpet is 5x marine cut loop pile, all of the wood was also sealed with polyurethane. There was also fiberglass repair in the foot tray.

 

This is a boat cushion than needs a complete rebuild. The other two were totally gone and could only get good measurements off  the one.

    !!!!! WARNING DO NOT TRY THIS AT HOME!!!!!

THIS WORK WAS PREFORMED BY A PROFESSIONAL

ANY ATTEMPT TO REPLICATE WILL RESULT IN LOST TIME, MONEY, AND POSSIBLY INJURY OR DEATH

 1) Cut wood and round the edges.

2) Glue foam to board.

3) Trim foam to size of board.

4) Measure all pieces of vinyl. (in this case blue & white)

5) Cut all vinyl pieces.

6) Glue all pieces to 1/2″ “Bonded Foam”.

7) Sew out side edge 1/8 ” . (all pieces)

8) Trim edges. ( this makes a complete “panel”)

8) Sew the top panels  (3) together then the sides(2). ( this makes the “skin”)

9) Fit the “skin” on foam frame and staple back.

10) Clean and inspect.

Ready to be installed on your boat.